David's Capstone Project

 I did some manual work to the truck because the drop springs that I bought off of another truck a the auto wrecker are not the best quality and they are very soft and the front left is lower than the other side so I putt a rubber spacer in between the spring and the housing but it still didn’t make it the same night so I will be buying new bell tech ones to replace them. I’m not upset about having to buy new bell tech springs because I only payed $30 for the ones that I have now 

 I have done more to my PowerPoint I have most of the weighting down but I still need to get some photos for a couple of them. I have 11 slides on what I have done since I got the truck. 

 This weekend I did some more work on the PowerPoint and I got 3 slides done and was looking at how much parts where going to cost   Website used for parts research  https://www.rockauto.com/en/catalog/chevrolet,2002,s10+pickup,2.2l+l4,2002565,engine

 Today I got started on my PowerPoint and was researching some of the complications I might run into