Posts

update #5

Image
 over the spring break i got a lot of work done, I was able to get a cherry picker ( the tool to take the engine out ) from one of my dads friends after I got the transmission out. I got the transmission apart and took a look inside and its not looking that bad. their are a couple of parts that I might need but they are unavailable for me to get. 
Post a Comment
Read more

update #4

Image
 I did some manual work to the truck because the drop springs that I bought off of another truck a the auto wrecker are not the best quality and they are very soft and the front left is lower than the other side so I putt a rubber spacer in between the spring and the housing but it still didn’t make it the same night so I will be buying new bell tech ones to replace them. I’m not upset about having to buy new bell tech springs because I only payed $30 for the ones that I have now 
Post a Comment
Read more

Update #3

Image
 I have done more to my PowerPoint I have most of the weighting down but I still need to get some photos for a couple of them. I have 11 slides on what I have done since I got the truck. 
Post a Comment
Read more

Update #2

Image
 This weekend I did some more work on the PowerPoint and I got 3 slides done and was looking at how much parts where going to cost   Website used for parts research  https://www.rockauto.com/en/catalog/chevrolet,2002,s10+pickup,2.2l+l4,2002565,engine
Post a Comment
Read more

First capstone post

Image
 Today I got started on my PowerPoint and was researching some of the complications I might run into 
Post a Comment
Read more